saving sound settings

Community Support question - to convert into a paid question, click here

Lines in bold below have not yet been seen by the customer - those in blue are from the customer

Username : Date : Action : Comments [ close all ]
paroyboy : 27/12/01 11:00 PM : Incident created -   Whenever I shut down my system, upon restarting, my volume level is reset to 0 for some reason beyond me! If I open the mixer and raise my levels, sound works fine until I restart, then it's back at 0. Any ideas? I use a SB PCI 128 which is identified by Linux as an Ensoniq 1370 I believe. Is this a common problem with an easy fix? Thanks in advance, Roy
Linegod_7611 : 27/12/01 11:35 PM : Reply received -   After you have finished setting your values in KMix, click on 'File' then 'Save current settings as default'. ----- Note: If this answer resolves your problem, please remember to close this question.
paroyboy : 28/12/01 02:13 PM : Incident closed -   I figured the sound problem was probably an easy fix. (volume levels reset to "0" after reboot) The "save current volumes as default" in the file menu did the trick. The next problem was that Kmix didnt have a menu bar. I had to dig deeper and find out that ctrl m would bring it back. Thanks Linegod for the fast response.

---